How to Adding an IUA Link Set?

This topic describes how to add an IUA link set. When configuring the VoIP ISDN service(thunder-link supply GPFD, GPBD), you need to configure the IUA link to carry the Q.931 call signaling. Before adding an IUA link, you must add a corresponding link set. Otherwise, the link cannot be added.

Context

• The system supports the configuration of a maximum of IUA link sets.
• After a link set is configured successfully, it is in the deactivated state by default.

Procedure

1. In global config mode, run the commandsigtran to enter the Sigtran mode.
2. Run the iua-linkset add command to add an IUA link set.
3. You can run the display iua-linkset attribute command to check whether the configured IUA link set information is the same as the data plan.

Example

Assume that the link set ID is 0, working mode of the link set is active/standby mode, pending duration is 20s, prefix of the IID is b/, IID generation mode is using the binary value that is automatically generated in ffsspp mode, namely, parameter 2. To add such an IUA link set, do as follows:

huawei(config)#sigtran

Related:




What’s the Failure of I-Type PDU Backplane on MA5600T due to Overcurrent



How to Assemble an IMPI on the MA5620G?



What is the command lines that we can use on the OLT to detect PRTE board status