Adding a Board
You can add a 10G GPON service board using either of the following
methods:
- Manually inserting a board: When 10G GPON boards have been configured in the subrack, manually insert a required board.
- Adding a board offline: When a 10G GPON service board needs to be
pre-configured, add a 10G GPON service board offline.
NOTE:
- In global config mode, run the board add frameid/slotidboard-type command to add a 10G GPON service board.
- After a board is successfully added offline, the board status is Failed. However, you can still configure or query data on the board.
- After a user manually inserts a board (the board type must be the same as that of the board added offline), the board status changes to Normal. Data configured for the board takes effect immediately after the configuration.
Configuring the Working Mode of a Board
Configure the working mode of a 10G GPON service board based on
actual requirements. The PON system supports the following modes:
- GPON mode
- XG-PON mode, that is, 10G GPON mode
Commands related to the working mode of a 10G GPON service board
are as follows:
- In diagnosis mode, run the display gpon board workmode command to query the working mode of a 10G GPON service board.
- In diagnosis mode, run the gpon board
workmode command to configure the working mode of a 10G GPON service
board.
NOTE:
A 10G GPON service board works in XG-PON mode by default.
More related:
No comments:
Post a Comment