The Ethernet OAM Configuration of display cfm mip(distributing-mode)

Function Description

Operation Administration & Maintenance (OAM) is an effective method used to reduce the cost of network maintenance. The MA5680T/MA5683T/MA5608T connects to the access convergence network through the upstream network port. OAM management packets start from or terminate at the upstream network port. You can perform OAM configuration management through NMS. NMS maintains the network based on the reported information of OAM status and alarms.

Function

This command is used to query the configuration of the connectivity fault management (CFM) MIP.

Format

display cfm mip vlan vlanid frameid/slotid/portid [ gemportid gemportid-value ] [ vlantag1 vlantag1-value [ vlantag2 vlantag2-value ] ]
display cfm mip vlan vlanid { frameid/slotid/portid | l2vpn }
display cfm mip vlan vlanid frameid/slotid/portid [ vpi vpi vci vci ] [ vlantag1 vlantag1–value [ vlantag2 vlantag2–value ] ]

Parameters

Parameter	Description	Value
vlan vlanid	Indicates that the configuration of the CFM MIP is queried by VLAN.	Numeral type. Range: 1-4094.
frameid/slotid/portid	Indicates the subrack ID, slot ID, and port ID. Enter a slash (/) between the subrack, slot, and port IDs.	Please see Differences Between Shelves.
gemportid gemportid-value	Indicates the ID of the GEM port. To create a maintenance end point (MEP) for a GEM port, use this parameter.	Numeral type. Range: 128-3999.
vpi vpi	Indicates the VPI value to be entered. It is used to identify a user when used with the VCI.	Numeral type. Range: xDSL board. Range: 0-255. Other boards. Range: 0-4095.
vci vci	Indicates the VCI value to be entered. It is used to identify a user when used with the VPI.	Numeral type. xDSL board. Range: 32-255. Numeral type. Other boards. Range: 32-65535.
vlantag1 vlantag1-value	Indicates VLAN tag 1, representing an outer VLAN receiving or sending packets.	Numeral type. Range: 1-4095.
vlantag2 vlantag2-value	IIndicates VLAN tag 2, representing an inner VLAN receiving or sending packets.	Numeral type. Range: 1-4095.
l2vpn	Indicates the MPLS Layer 2 virtual channel.	-

Modes

Privilege mode

Level

Operator level

Usage Guidelines

None

Example

To query the configuration of the CFM MIP of VLAN 2 in the 0/19/0 port, do as follows:

huawei#display cfm mip vlan 2 0/19/0
  MIP Level           : 0
  MIP MAC             : 00E0-FC00-0142

System Response

• The system displays the queried result when the command runs successfully.
• The following table describes the parameters in response to this command.

  Parameter	Description
  MIP level	Indicates the MIP level. You can run the cfm md command to set the parameter.
  MIP MAC	Indicates the MIP MAC address. When you run the cfm disable command to disable the CFM function, the system displays "-".

More blog:

When cannot log-in MSUITE of U2000V1R3.

How to change the OLT type device?

How many Remote frame ( RSU with HABD ) can UA5000-PVM board support?