ont-port eth(dpoe)
Function
This command is used to set the port capability of the ONT in the EPON ONT
service profile. The capability set plans the number of various ports supported
by the ONT. The port capability set in the ONT service profile must be
consistent with the actual capability set of the ONT. Currently, the system only
supports the configuration of the ONT Ethernet port. By default, the number of
ONT Ethernet ports in the EPON ONT service profile is zero.
Parameters
| Parameter | Description | Value |
|---|---|---|
| eth-port | Sets the number of Ethernet ports on the ONT(like HG8245A,HG8245H). | Numeral type. Range: 0-8. |
| adaptive | Indicates adaptive mode. The system automatically adapts the number of ports to the actual number of the ONT Ethernet ports.based on the capability of the online ONT. | - |
Usage Guidelines
- Run the config command to enter global config mode, and then run the ont-srvprofile epon command to enter EPON ONT service profile mode.
- When you reduce the number of ports, the system displays a message prompting that the operation may delete ports that are not within the configuration range. In addition, the system asks the user to confirm whether to perform the port reduction operation.
- The number of each type of ports on the ONT must be consistent with the actual hardware capability of the ONT. Otherwise, the port state is mismatch. You can run the display ont capability(dpoe) command to query the actual hardware capability of the online ONT.
- You can run the display ont-srvprofile epon(dpoe) command or the display ont info(dpoe) command to query the ONT port capability in the EPON ONT service profile.
Example
To configure the umber of Ethernet ports in ONT line service profile 2 to 2,
do as follows:
huawei(config-epon-srvprofile-2)#ont-port
{ eth<K> }:eth
{ adaptive<K>|eth-port<U><0,8> }:2
Command:
ont-port eth 2
No comments:
Post a Comment