GPON Access Port Management(port dba surplus-assignment)

port dba surplus-assignment(gpon)

Function

This command is used to set the pre-allocation function of the remaining bandwidth for a GPON port.

Format

port dba surplus-assignment portid surplus-assignment-switch

Parameters

Parameter	Description	Value
portid	Indicates the ID of a GPON port..	Please see Differences Between Shelves.
surplus-assignment-switch	Indicates the pre-allocation function of the remaining bandwidth. Options: enable and disable. Enable: Enables the pre-allocation function of the remaining bandwidth. Disable: Disables the pre-allocation function of the remaining bandwidth.	-

Modes

GPON mode

Level

Operator level

Usage Guidelines

• Run the config command to enter the global config mode, and then run the interface gpon command to enter the GPON mode.
• Currently, only the H802GPFD, H803GPFD, H806GPBD, H806GPBH, H801GPMD, H805GPFD, H807GPBD, H807GPBH, and H801XGBD boards support this command.

Example

To enable the pre-allocation function of the remaining bandwidth for GPON port 0, do as follows:

huawei(config-if-gpon-0/13)#port dba surplus-assignment                    
{ portid<U><0,15> }:0   
{ surplus-assignment-switch<K><enable,disable> }:enable                       
                                                                                
  Command:                                                                      
          port dba surplus-assignment 0 enable                                         

System Response

• The system does not display any message after this command is executed successfully.

Parent topic: 

When the NMS Fail to Synchronize ONUs.

When Prewarning on Service Unavailability of H806GPBH & H806GPBD Boards of MA5600T

When Display Change of Service Ports and Service Failure in the MA5600T?