Common xPON Upstream Port Management----display password(ponnni)

Function

This command is used to query the password of the PON ONU when log in the OLT.

Format

display password

Parameters

None

Modes

GPONNNI mode, EPONNNI mode, OptiX OSN 7500OSN 3500OSN 2500

Level

Operator level

Usage Guidelines

• Run the config command to enter global config mode, then run the interface gponnni command to enter GPONNNI mode.
• Run the config command to enter global config mode, then run the interface eponnni command to enter EPONNNI mode.

Example

In GPONNNI mode, to query the password of the GPON ONU, so as follows:

huawei(config-if-gponnni-0/19/0)#display password
 GPON ONU password: huawei

In EPONNNI mode, to query the password for an EPON ONU to register with the OLT, do as follows:

huawei(config-if-eponnni-0/19/0)#display password
 EPON ONU password: huawei

System Response

• The system displays the queried result when the command runs successfully.
• The following table describes the parameters in response to this command.

  Parameter	Description
  GPON ONU password	The password of the GPON ONU when log in the OLT.
  EPON ONU password	The password for EPON ONU to register with the OLT.

• For more information about the error message that the system displays against a command entered with incorrect syntax

MORE BLOG:

What’s the Failure of I-Type PDU Backplane on MA5600T due to Overcurrent

How to do when Occasional MA5616 Database Clearing?

What are the meanings of the short names of UA5000 boards