ONT Multicast Service Management----display simulation multicast ont

Function

This command is used to query information about ONT multicast simulation instances being performed.

Format

display simulation multicast ont [ frameid/slotid/portid ontid ]

Parameters

Parameter	Description	Value
frameid/slotid/portid	Indicates the shelf ID, slot ID, and port ID. Enter a slash (/) between the shelf, slot, and port IDs.	Please see Differences Between Shelves.
ontid	Indicates the ONT index. This parameter and frameid/slotid/portid collectively identify an ONT(like HG8245H, HG8545A).	Please see Differences Between Shelves.

Modes

Privilege mode

Level

Operator level

Usage Guidelines

If the subrack/slot/port ID and ONT ID are not specified, the system queries information about multicast simulation instances being performed for all ONTs in the system.

Example

To query information about multicast simulation instances of ONT 0 on port 0/2/0, do as follows:

huawei#display simulation multicast ont 0/2/0 0

  Command:
          display simulation multicast ont 0/2/0 0
  -----------------------------------------------------------------------------
  Instance(F/S/P/ONTID)   : 0/2/0/0
  ONT port                : ETH 1
  Multicast group IP      : 224.1.1.1
  Multicast source IP     : 1.2.3.4
  User IP                 : 10.0.0.1
  User MAC                : 00e0-fc01-0001
  VLAN ID                 : 100
  Priority                : 5
  User version            : IGMPv2
  Simulate status         : finished
  Simulate result         : success
  Data rate(kbps)         : 1500
  Simulate start time     : 2014-09-24 15:49:20+08:00 
  -----------------------------------------------------------------------------
  Total: 1

System Response

• The system displays the queried result when the command runs successfully.
• The following table describes the parameters in response to this command.

  Parameter	Description
  Instance(F/S/P/ONTID)	Indicates the shelf ID/slot ID/port ID and ONT index of the ONT multicast simulation instance.
  ONT port	Indicates the ONT port ID.
  Multicast group IP	Indicates the IP address of the multicast group.
  Multicast source IP	Indicates the multicast source IP address.
  User IP	Indicates the user IP address.
  User MAC	Indicates the user MAC address.
  VLAN ID	Indicates the user VLAN.
  Priority	Indicates the priority.
  User version	Indicates the multicast version.
  Simulate status	Indicates the simulation state.
  Simulate result	Indicates the simulation result.
  Data rate	Indicates the data rate.
  Simulate start time	Indicates the time when the simulation instance starts.

• For more information about the error message that the system displays against a command entered with incorrect syntax.

MORE BLOG:

What are the meanings of the short names of UA5000 boards

Description on the flow control of the NG SDH EFT data board

When Install SLQ4 board on slot 1 to slot 4 in OSN 3500?