The ONT Ethernet OAM Configuration on display cfm

Function

The display cfm command is used to query the global connectivity fault management (CFM) configuration of a specified ONT. The ONT CFM is enabled by default.

Format

display cfm frameid/slotid/portid ontid

Parameters

Parameter	Description	Value
frameid/slotid/portid	Used to identify the frame ID, slot ID, and port number. "/" must be input.	Please see Differences Between Shelves.
ontid	Indicates the ONT ID. This parameter and the frameid/slotid/portid identify a unique ONT.	Numeral type. Range: varies with the board type.

Modes

ONT ETH OAM mode, HG8245H, HG8245A

Level

Operator level

Usage Guidelines

Run the config command to enter the global configuration mode. Then, run the ont-ethoam command to enter the ONT ETH OAM mode.

Example

To query the global configuration of CFM of ONT 0 on port 0/2/0, do as follows:

huawei(config-ont-ethoam)#display cfm 0/2/0 0
  Command:
          display cfm 0/2/0 0
  CFM Global Status        : disable

System Response

• The system displays the queried result when the command runs successfully.
• The following table describes the parameters in response to the command.

  Parameter	Description
  CFM Global Status	Indicates the global CFM enable status. You can run the cfm command for configuration.

More blog:

Broadcast storm occured in S5300 when STP was ruuning

When Failed to get the SNCP state of N3EAS2 board, NMS error code 38752

When compatible stp mode in S5700 Huawei switch with pvst in cisco switches?