GEM Port Management about display ont multicast gemport

Function

The command is used to query T-CONTs and port mapping attributes for ONT multicast GEM ports.

Format

display ont multicast gemport portid ontid

Parameters

Parameter	Description	Value
portid	Indicates the ID of the GPON port.	Please see Differences Between Shelves.
ontid	Indicates the ID of the ONT port.	Numeral type. Range: varies with the board type.

Modes

GPON mode, MA5683T, GPBD

Level

Operator level

Usage Guidelines

Run the config command to enter global config mode, and then run the interface gpon command to enter GPON mode.

Example

To set query the GEM port attributes for ONT 0 connected to GPON port 0/3/0, do as follows:

huawei(config-if-gpon-0/3)#display ont multicast gemport                           
{ portid<U><0,7> }:0 
{ ontid<U><0,63> }:0 
                                                                                
  Command:                                                                      
          display ont multicast gemport 0 0 
  ------------------------------------------------------------------------------
  F/S/P              : 0/3/0                                                    
  ONT-ID             : 0                                                        
  T-CONT ID          : 5                                                        
  Bundle ID          : 1                                                        
  ONT port ID        : -                                                        
  ------------------------------------------------------------------------------

System Response

• The system displays the queried result when the command runs successfully.
• The following table describes the parameters in response to the command.

  Parameter	Description
  T-CONT ID	Indicates the T-CONT ID.
  Bundle ID	Indicates the bundle ID.
  ONT port ID	Indicates the ONT port ID.

More related:

When End-to-End GE Services Cannot Be Created on the OptiX OSN 6800?

How to Use the Multimeter to Check Whether the A32 Board Is Faulty?

Due to disabling TDC-ADJUSTENABLE function high Bit errors on NS3 card