xDSL Board Management(board workmode)

board workmode

Function

This command is used to set the voice or SATop broadband mode as the working mode of a board. When a board needs to change from the voice mode to the SATop broadband mode, or vice versa, run this command. After the command is executed successfully, the preset working mode of a board takes effect.

CAUTION:

In the normal state, running this command successfully causes the board to reset. Therefore, exercise caution when running this command.

Format

board workmode mode

Parameters

Parameter	Description	Value
mode	Indicates the working mode of the board. Two working modes are available: voice: Indicates the voice mode. In this mode, the ISDN voice service is provided, or the signaling flow and medium stream of the IP network are transparently transmitted. satop: Indicates the satop broadband mode. In this mode, the E1 or V.35 service is connected through 16 G.SHDSL ports and transmitted upstream to the SDH network or DDN network through E1.	Enumerated type. Options: voice and satop. Default: voice.

Modes

EDT mode, SHDSL mode, OSN 3500, GPBD

Level

Operator level

Usage Guidelines

• Run the config command to enter the global config mode, and then run the interface edt command to enter the EDT mode or run the interface shl command to enter the SHDSL mode before running this command.
• This command is supported by only the H802EDTB board.
• When a board is in the normal state, or in the failed state (including offline adding state and disabled state), its working mode can be modified. If a board is in any other state, its working mode cannot be modified.
• Make sure that the services configured on the board are deleted first and then you can modify its working mode.
• You can run the display board workmode command to query the working mode of a board.

Example

To set the SATop broadband mode as the working mode of board in slot 0/3, do as follows:

huawei(config-edt-0/3)#board workmode
{ mode<E><voice,satop>}:satop
                                                                                
  Command:                                                                      
          board workmode satop                                                  
  Success: Set the board workmode success                                       

System Response

• The system displays the message "Changing the working mode may cause loss of certain configuration data, and then the board will be reset. Are you sure to continue? (y/n)[n]:" if the board is in the normal state when this command is executed.
• The system displays the message "Success: Set the board work mode success" after the working mode of a board is successfully set.

MORE:

When OSN 1500 R1PCXLN board fails to query optical power due to software BUG?

How to Install SLQ4 board on slot 1 to slot 4 in OSN 3500?

What’s the Ethernet features in terms of function of the OptiX OSN 1500 V1R2?